View Single Post
Old Aug 23, 2012, 02:21 PM
speedy01 is online now
Find More Posts by speedy01
Registered User
Gulf Breeze, FL
Joined Jul 2006
3,704 Posts
Quote:
Originally Posted by glewis View Post
Curious if you could run depron through the laser printer.
No, no, no.....NO! Besides being too thick, you'd lose it all on the very hot fuser!

Quote:
What glue are you using?
Mainly UHU Por as I detailed in Pete's NP-11 Thread that I mentioned up front. Good info there.

Naptha is great for UHU cleanup - it will remove excess on seams without any bad effects on the foam or tissue (much better than rolling up little gum balls with your finger). Just use a "dampy" paper towel and don't flood the seam else it will dissovle . Naptha is also useful for thinning the UHU.

Thanks to a tip from Freddie B, I tried Elmer's Rubber Cement to laminate foam (as for a cowl), and it's perfect for sanding edges without raising gum balls or riges as UHU would.

I'm away from home, and hopefully won't have to return early to board-up for Hurricane Isaac! Also hope it will spare you too, Glenn!

Gene K
speedy01 is online now Find More Posts by speedy01
Reply With Quote