Thread: Discussion Stator coating
View Single Post
Old Aug 20, 2012, 11:48 PM
KKUSA is offline
Find More Posts by KKUSA
Registered User
United States, IN, Indianapolis
Joined Oct 2010
1,030 Posts
Quote:
Originally Posted by vtdiy View Post
I also wouldn't use the plastic welder to try to melt a powder coating. The airflow would likely blow the powder off! An oven or hot stator sounds much better.

I don't have experience with the two listed HF welders. Mine is an older model that came with a low pressure adjustable regulator. That and a router speed controller allows control of both airflow and temperature.

If I were to buy one now, I'd by the less expensive one (no fan) and add a low pressure regulator.

Yea, dont use anything that "blows" to flow the powder, it WILL blow away.
KKUSA is offline Find More Posts by KKUSA
Reply With Quote