Thread: Discussion Stator coating
View Single Post
Old Aug 20, 2012, 05:13 PM
vtdiy is offline
Find More Posts by vtdiy
low tech high tech
vtdiy's Avatar
Southern Vermont
Joined Feb 2007
3,029 Posts
I also wouldn't use the plastic welder to try to melt a powder coating. The airflow would likely blow the powder off! An oven or hot stator sounds much better.

I don't have experience with the two listed HF welders. Mine is an older model that came with a low pressure adjustable regulator. That and a router speed controller allows control of both airflow and temperature.

If I were to buy one now, I'd by the less expensive one (no fan) and add a low pressure regulator.
vtdiy is offline Find More Posts by vtdiy
Reply With Quote