View Single Post
Old Aug 19, 2012, 01:37 PM
xrotor_rg686 is offline
Find More Posts by xrotor_rg686
Registered User
Joined Mar 2012
74 Posts
Quote:
Originally Posted by laverre View Post
Yes good, i have tested with bec and that's ok
But the servo doesn't want to move, if i move the multirotor it's blocked.
If i make init, the gimbal comes on the middle ( good position) but if i stop init the gimbal goes on the corner.
i don't understand what happens
Did you connect the ch7 and ch8 of Ys-x6 to your receiver? I think you need it for the gimbal to work.
xrotor_rg686 is offline Find More Posts by xrotor_rg686
Reply With Quote