Thread: Discussion Made a few steps forward
View Single Post
Old Aug 17, 2012, 06:33 PM
cwg25 is offline
Find More Posts by cwg25
You Enjoy Myself
United States, NC, New Bern
Joined Jul 2012
77 Posts
Discussion
Made a few steps forward

I had a friend help me with soldering and learned the solder I was using wasn't good, even though it was 60/40 rosin.

We tried another brand and it worked fine. I'm able to solder now and attached the deans connector wire to the board and the wires for the receiver.

I was able to connect just about all the wires to the naza and receiever. There are two wires from the on/off switch I'm not sure where to attach, if I even need to. I see one of these can fit in the receiver or naza unit. The second I'm not sure where it goes. The third is attached to the data port on the receiver, I know that goes there.

I've stopped short of attaching the GPS unit. And I haven't affixed the naza unit, reciever, or LED unit to the plate yet. Zip ties hold down the ESCs.

Any comments, suggestions, or constructive criticism would be appreciated.
cwg25 is offline Find More Posts by cwg25
Last edited by cwg25; Aug 18, 2012 at 09:40 AM.
Reply With Quote