View Single Post
Old Aug 15, 2012, 11:53 AM
H&H is offline
Find More Posts by H&H
H&H Hobbies
H&H's Avatar
Old mystic CT U.S.A.
Joined Nov 2003
654 Posts
Originally Posted by Thetis View Post
I was wondering if CarlP is currently reading this thread so, you guys can compare notes. As I mentioned before I am not so lucky with the brushed B motor I need a new one (third in a row) or install the HK BL.
You should be able to install the BL in an evening if you have all the parts.
I installed the factory BL set and a new shaft set in less than an hour.
One thing to make sure is that you keep the botton motor from directly touching the plastic mounting surface. (the motor can get very hot) The factory setup provides a piece of PC board material in between the motor and the bottom plate to block the heat.
H&H is offline Find More Posts by H&H
Reply With Quote