View Single Post
Old Aug 15, 2012, 11:04 AM
JohnnyMc is offline
Find More Posts by JohnnyMc
RC Dirt Bike Action
JohnnyMc's Avatar
California central coast
Joined Feb 2010
1,951 Posts
slipper material

Jim, I found this on page 117 (good discussion about subject on this page) after doing a search in this thread - see blue bar towards top of this thread. I used the search words "slipper material" and made it show the posts. I didnt go much further in search. I might see if my sc10 has slipper pad shaped like the vmx slipper material, but doubt it. Wont know until tonight.
Quote:
Originally Posted by RICH S View Post
I successfully used gasket material from the auto parts store, it's about .060 in thick, I used 2 pieces ca'd together and cut out the octagon shape, it worked pretty good until I got a new gear. The 1/8 scale buggies are nice, we have a big indoor local track with a ventalation system to run nitro in the winter and they are impressive, very big air
While Im at it, an extra tip passing on about better resolution with slipper adjustments is to add 2 more coned washers under the nut when getting slipper tight, so it would looke like )()( instead of )( - unless manual has it reversed order then its ()() instead of (). I forget. LOL.
JohnnyMc is offline Find More Posts by JohnnyMc
Last edited by JohnnyMc; Aug 15, 2012 at 11:11 AM.
Reply With Quote