View Single Post
Old Aug 15, 2012, 10:40 AM
Xermalk is offline
Find More Posts by Xermalk
Registered User
Sweden, Helsingborg
Joined Jun 2012
4,045 Posts
i went directly to a mini from a v911 and dont have mutch experience. But getting of the ground into a hover is very easy with the minicp.

What you should do is give just enough thrust to get the mini to skid along the ground, then drain a battery or two just getting used to the feeling of the cyclic stick.

Then when you feel confident give it that extra stick movement to get it into a hover.

Now, i just noticed something on my mini, the mainshaft can be moved up/and down by about 1-1.5mm, I'm presuming this is whats causing me to have issues keeping it on a fixed level when wind pushes it.

Now, is this intended with a feathering shaft? or can i put a small washer above the maingear? Because this causes quite abit of movment of the blade pitch.

PS. How do you remove the main gear? i cant see any screw like on the v911.
Xermalk is offline Find More Posts by Xermalk
Last edited by Xermalk; Aug 15, 2012 at 10:58 AM.
Reply With Quote