View Single Post
Old Aug 13, 2012, 09:41 PM
Jboy90277 is offline
Find More Posts by Jboy90277
Registered User
United States, CA, Palos Verdes Peninsula
Joined Dec 2011
1,031 Posts
EPP is EPP. FoamTac, Welders or Uhu Por should work well. Thick CA takes a while to cure unless you kick it. I'm going to use Welders where I can. I might experiment with FoamTac or Uhu Por to hold the hinges. I'll soak the motor mount with thin CA or maybe even epoxy. The landing gear box will get a coat of epoxy (like the buck huck).

Here's what happens when CA migrates to the wrong place. This was a quick field repair to get flying again as soon as possible.
Jboy90277 is offline Find More Posts by Jboy90277
Last edited by Jboy90277; Aug 13, 2012 at 09:58 PM.
Reply With Quote