View Single Post
Old Aug 13, 2012, 09:33 PM
robj is offline
Find More Posts by robj
Registered User
robj's Avatar
United States, LA, Moss Bluff
Joined Nov 2008
8,431 Posts
Quote:
Originally Posted by nickelbn1 View Post
but i was using the y harness in my balsa extra and it was flying just fine. why would a y harness cause problems in the ailerons? I am using a AR500 rx, so its 5 channel. how do I plug in two aileron wires when there is only one aileron port?
It really shouldn't matter. Using a separate channel for each aileron allows you to program the end points independently. With a Y cable and doing it mechanically, you might be able to get it spot on, but maybe not. There might be some other reasons to.

On the thrust angle, the only plane I had to mess with was my 38 epp slick. Those are a little different but I had to put in a lot of right rudder to keep it from dog walking. After some research the rule is if you need right rudder, then the motor needs to point more right. All the other surfaces were normal. One washer did it. It might have been my build but I was glad to get it fixed. I just sold it to get this baby. Might have been some other ways to test and fix it but this one worked for me.

Wish I had my servos for this Edge!
robj is offline Find More Posts by robj
Reply With Quote