View Single Post
Old Aug 13, 2012, 12:46 PM
ricoalonso is offline
Find More Posts by ricoalonso
Registered User
ricoalonso's Avatar
USA, KS, Derby
Joined Mar 2003
1,482 Posts
Michael,
No problem. Here's a copy of my config file. Most of the values are default except for 3D Direct Rate is enabled with HH disabled, Servo Range were also modified to custom 1100 - 1900 limits. I did not spend much time in servo limits since this is EPP foam and things will just stretch a little if ever the servo has a little over-max. If you load the config, you should be able to see my pot gain settings... which I think is almost 75% for all three. I am flying with a simple 4-ch Rx so no master gain control and is always at 40% (default).
ricoalonso is offline Find More Posts by ricoalonso
Reply With Quote