View Single Post
Old Aug 12, 2012, 08:04 PM
BrownEyedFool is offline
Find More Posts by BrownEyedFool
You're killin' me Smalls
BrownEyedFool's Avatar
United States, NJ, Hillsborough Township
Joined Sep 2011
1,853 Posts
Redoing some hinging on my Extra slick, using Blenderm at the moment.

Should i be closing that gap between the points of the two beveled edges or leaving a gap? 1/16"? 1/32"?

I assume Blenderm is an acceptable hinge replacement over Welder's, I have trouble getting the Welder's thin enough.
BrownEyedFool is offline Find More Posts by BrownEyedFool
Reply With Quote