View Single Post
Old Aug 12, 2012, 10:19 AM
Xermalk is online now
Find More Posts by Xermalk
Registered User
Sweden, Helsingborg
Joined Jun 2012
4,045 Posts
Ill likely be doing the server saver on my MiniCP today (tx arriving tomorrow), and i'm wondering if it needs to be done to all servos? i can access 2 of them without removing anything else, but the pitch servo will require that i remove the rx board.

Also, i don't have any washers lying around that fits so ill use shrink tubing, just not sure how well it will hold the arm together.
The area it can tighten is very small, (Genius servo arms looks like they have a mutch larger area to put a washer/shrink tube on).

Ill also be fixing the rx coil & Battery/rx antenna wires with some hot glue. As they look somewhat exposed.
Xermalk is online now Find More Posts by Xermalk
Last edited by Xermalk; Aug 12, 2012 at 10:52 AM.
Reply With Quote