View Single Post
Old Aug 11, 2012, 07:15 PM
gnats82 is offline
Find More Posts by gnats82
Coy, peruser of worlds
gnats82's Avatar
Augusta, KS USA
Joined Dec 2007
5,440 Posts
Scrauper -

On the sequencer, plugs will go white wire to the inside of the unit, black to the outside.

Be sure to check out the "Big, big, big ..." Hobby King P-40 thread. If this is your first airplane of this caliber, you'll need more information. This P-40N is a gem in some ways but tests even seasoned modelers due to the work needed to get it flight worthy, especially the retracts.

I messed up getting the plugs correct at the sequencer, didn't harm a thing. One way it works, the other it doesn't. It has a monitor l.e.d. to help.

Edit : The feed wire from the sequencer goes into ch. 5 on your rxr. The labelled wires from the retracts and gear doors go into the labelled ports on the sequencer, black wire to the outside.

They furnish "Y" harnesses to combine the wiring from the two wings. Thus, both ailerons will "Y" into one and it will go to the ail. port on your rxr. Same for the flaps ("Y" into port #6), retracts, and gear doors. All are pretty well labeled.
gnats82 is offline Find More Posts by gnats82
Last edited by gnats82; Aug 11, 2012 at 07:54 PM.
Reply With Quote