Thread: Discussion Stator coating
View Single Post
Old Aug 10, 2012, 11:18 AM
vtdiy is offline
Find More Posts by vtdiy
low tech high tech
vtdiy's Avatar
Southern Vermont
Joined Feb 2007
3,029 Posts
Quote:
Originally Posted by zeroback View Post
Thanks for the tips. The problem I have had with the epoxy (JB weld 24hr cure)
I believe JB Weld has powdered metal in the formulation, if that's important to you. Also, OTC epoxies generally cure and increase in hardness over a long period of time, not just overnight.

Hardness and cure also depend on mixing quality and proportions -- hard to achieve good quality mixes with a pre-thickened OTC glue epoxy squeezed in small amounts, measured by eye, out of a couple of tubes, and then stirred with a stick for a minute.

There will be a lot of uncured resin and hardener in the cured coating.
vtdiy is offline Find More Posts by vtdiy
Reply With Quote