View Single Post
Old Aug 08, 2012, 01:48 PM
rcjose is offline
Find More Posts by rcjose
Registered User
United States, TX, Richmond
Joined Aug 2010
1,283 Posts
Quick and dirty guide to flashing the KK2 board

Ok, here is a quick and dirty guide on how to flash the KK2 board using LazyZero's Flashtool. It's just the very basics on where to get the tool, the latest firmware and how to use the tool.

Please note that I do not have the KK2 board with me at this time so i could not include directions on how to connect it to your pc via a USB programmer or show the actual status messages when flashed.

If I get a chance to flash my KK2 board tonight, I will create a detailed video and then post it on my youtube channel and then a message here with the link to the video.

For those that have already flashed it

1. Where is PIN 1 on the programming header on the KK2 board?
2. Did you power the KK2 board via your USB/ASP programmer or via an ESC/BEC connected to motor header 1?
rcjose is offline Find More Posts by rcjose
Reply With Quote