Originally Posted by b.b.4
Can someone tell me WHY the motor shaft in the Bixler came loose inside the motor.? The shaft slid back into the motor and is free spinning. I can pull it back out and the motor will run, but the shaft slowly slids back inside and won't spin the prop. Is there an E-clip inside the motor that came off or broke ? The plane did not crash, it just came loose doing while flying ?????????
If I recall mine did the same. There was no clip on the end, of if there was it must have come off.
I dumped the motor and replaced it with a 1400kv that I had in stock.