View Single Post
Old Aug 07, 2012, 10:57 AM
0 teo is offline
Find More Posts by 0 teo
Registered User
Athens, Greece
Joined Oct 2010
37 Posts
Discussion
Quanum 2.4Ghz Transmitter - Problem - Please help!

Hi there all,

I am following the properly procedure to bind Quanum 2.4Ghz Telemetry System Tx-Rx but the Rx after the bind ends shows only "0,00V" while in connection and after that "No Signal!" without connection (shows like the bind get gone).

What is going wrong?
Can I recall the default settings?
Is there any service for this device?

Please help

Regards,
Teo
0 teo is offline Find More Posts by 0 teo
Reply With Quote