View Single Post
Old Aug 07, 2012, 07:36 AM
philip frank is offline
Find More Posts by philip frank
Registered User
ft. worth
Joined Jul 2004
916 Posts
I did not mess with the trim. Will try that. I have always referred to the castle throttle calibration video on youtube in the past with no issues. I just was unable to get the arrow to move to the high position last night when attampting to to that.

I have set the throttle settings in the 160 software to set rpm and then entered desired headspeeds in the headspeed boxes on the throttle tab. That has always worked in the past. Should I try another setting besides set rpm? This is being set to a scorpion 4525-520 motor in a 90 sized electric.
philip frank is offline Find More Posts by philip frank
Reply With Quote