View Single Post
Old Aug 03, 2012, 10:09 PM
flyhigh300 is offline
Find More Posts by flyhigh300
Registered User
United States, TX, El Paso
Joined Nov 2010
762 Posts
2mm ?

My plan was to use 2mm .. I've used them before .. and thread them into G10 ..

I use a 5/64 drill bit to drill the motor mount 2mm screw goes right through it..

drill with 1/16 bit and thread the G10 with the screw.



Quote:
Originally Posted by kad View Post
Dial,
What size/type of fasteners did you design the motor mount holes on the mini for? They seem to be about 1.5mm in width, but nobody around here has anything even close to that small. I thought about zip ties, but can't find any that small either.

-K

("Around here" includes two LHS, two home centers, an old fashioned hardware store, a Fastenall, a Sarjo Fasteners, and a Grangers Industrial Supply.)
flyhigh300 is offline Find More Posts by flyhigh300
Reply With Quote