View Single Post
Old Aug 01, 2012, 06:49 PM
kensp is offline
Find More Posts by kensp
Registered User
kensp's Avatar
Darwin Australia
Joined May 2002
6,960 Posts
The mount I used is this one. http://www.hobbyking.com/hobbyking/s...idproduct=3613

The round mount is removed from your motor and the new mount is slipped over the tube projecting from the rear.Then the pinch bolt is tightened. Two screws are put into the side of the square part of the mount lock the mount onto the stick.This mount has the correct offset.

Ken
kensp is offline Find More Posts by kensp
Reply With Quote