View Single Post
Old Jul 31, 2012, 09:40 AM
PeterVRC is offline
Find More Posts by PeterVRC
Registered User
Australia, VIC, Melbourne
Joined Nov 2006
13,924 Posts
For the ESC, I decided to make the ESC end wires very short, and extend the motor wires so they reach that then. This is so the motor wires can be taped to the CS10 housing and make it an easier assembly to get into place (or out again). Not a 'must do' thing but it worked out well.

The ESC is velcroed up front.
An airflow hole is cut in the front bulkhead to allow air to pass over the ESC.
This also needs a hole to be cut into the nose gear cover piece.

...
PeterVRC is offline Find More Posts by PeterVRC
Reply With Quote