View Single Post
Old Jul 31, 2012, 09:36 AM
PeterVRC is offline
Find More Posts by PeterVRC
Registered User
Australia, VIC, Melbourne
Joined Nov 2006
13,934 Posts
I dremelled out the EDF housing bay to be longer by about 8mm, so the CS10 stock housing can fit in properly.
The CS10 has its mounting lugs offset from centre a bit, so when you sit the fan into the upper fuselage its mounts do not get to the foam. This is a GOOD thing as it turns out, because is allowed placement of plywood mounting plates so that the CS10 can be screwed in.

Once they ply plates are epoxied in (on), the EDF cover actually just fits right on correctly anyway. But even if it didn't, it would just need a bit of foam cut out at the CS10 mount points.

The CS10 only needs two screws to hold it in fine.

...
PeterVRC is offline Find More Posts by PeterVRC
Reply With Quote