View Single Post
Old Jul 31, 2012, 09:26 AM
diegogonz76 is offline
Find More Posts by diegogonz76
Registered User
Joined Jul 2012
26 Posts
Plastic blade hinges

Hi Lee, I've been reading this thread (up to page 41) and I decided to buy this helicopter for my son, mostly for your comments. I have a problem with tracking and my blade hinges are made of plastic, the hole thing, not just the middle part. And the lower hinge has a plastic cylinder thart holds the blade in place even without the screw. The problem is that this cylinder is not allowing me to reduce the conning angle below 6 mm. I was wondering if there is a method for bending/twisting/adjusting this kind of hinges (hope is not in page 42). Also the lower big gear is not perfectly horizontal. I assume the only way to correct this is heating and bending it. I find it hard to see where to apply heat only to that gear.
English is not my native language so I hope I made myself clear. Thanls for all the things I've learned reading this thread!!

Found a page where you can see the blade hinges and the balance bar that also seems different:
http://www.feala.com/QS5888-GT-model...pare-Parts.htm

Also found this set, perhaps I can buy it and replace the whole ting. I wonder if it fits in my 5888.
http://www.goldenhobby.com/G-T-5888-...are-p-714.html
diegogonz76 is offline Find More Posts by diegogonz76
Last edited by diegogonz76; Jul 31, 2012 at 12:21 PM.
Reply With Quote