Originally Posted by flyhigh300
Here is the first one...
few minor Issues to work out..
I made it form 1mm G10 ..
the V tail support is 1.5mm and the gear is 1.5mm ( as the smallest tool I cut with is 1/16)
This allows for a good fit..
one "problem" is.. the 1mm sheets.. do not allow the screws to compress..
using.. 1/4 standoffs.. and 3/16 screws from top and bottom..so the G10 is not thick enough..
So solution is.. go to 1.5mm sheets.. or add a small washer..
hmm but I rather like it as it is.. frame.. weight.. G10 part came in at 2.7oz..
I'll put all the screws in it and see what the weight comes in at..
motors I plan to use..
Omg i want this puppy!
Can't wait to see it flying!