View Single Post
Old Jul 28, 2012, 12:15 AM
flyhigh300 is offline
Find More Posts by flyhigh300
Registered User
United States, TX, El Paso
Joined Nov 2010
762 Posts
Here is the first one...

few minor Issues to work out..

I made it form 1mm G10 ..

the V tail support is 1.5mm and the gear is 1.5mm ( as the smallest tool I cut with is 1/16)

This allows for a good fit..

...

one "problem" is.. the 1mm sheets.. do not allow the screws to compress..

using.. 1/4 standoffs.. and 3/16 screws from top and bottom..so the G10 is not thick enough..

So solution is.. go to 1.5mm sheets.. or add a small washer..

.....

hmm but I rather like it as it is.. frame.. weight.. G10 part came in at 2.7oz..
I'll put all the screws in it and see what the weight comes in at..

......

motors I plan to use..

http://www.hobbyking.com/hobbyking/s...nner_10g_.html

....
flyhigh300 is offline Find More Posts by flyhigh300
Reply With Quote