Thread: Discussion Help with esc
View Single Post
Old Jul 27, 2012, 08:43 PM
shmiser is offline
Find More Posts by shmiser
Registered User
Joined Aug 2011
64 Posts
Esc Help

Quote:
Originally Posted by Evil Twin View Post
You most likely won't be happy with a plane/helicopter esc for a car unless you just want to go forward and don't need reverse or brakes. Plane esc's have limited brake function to stop the prop from freewheeling because it causes drag. When the stick goes all the way down it will turn on a preset brake of low medium or high (dependent on manufacturer and model), not proportional like you want on a car. The reverse is a programable function, it's either on or off. You would need a programming card or a complex process of plug battery in, listen for tones, stick up/down through tone menu and then stick up/down to changes settings. Usually it's quicker to swap two wires on a brushless system, swapping 2 of the 3 motor leads reverses the direction.

The motor link no longer works, but it sounds like the motor rpm was a mechanical failure rpm, the point at which the magnets fly off the rotor. Usually you don't have to worry about hitting that unless you are running high voltage or a it's a very high kv motor. So most esc's should handle the actual rpm that you will be running at.
Hi.Here is the motor link again;

http://www.ebay.com/itm/RCTIMER-2030...ht_2970wt_1037

Can you please tell me which esc will be good for it from ebay.
shmiser is offline Find More Posts by shmiser
Reply With Quote