Thread: Build Log Thermal BLEED
View Single Post
Old Jul 26, 2012, 06:41 PM
Quick61 is offline
Find More Posts by Quick61
Just call me crash for short
Quick61's Avatar
United States, OH, The Plains
Joined Jan 2011
1,703 Posts
Still moving forward, got the control linkage set up, servos wired, more sanding and the first powered test done so far today. And with that, the first video of the wing, floor flying!

Some more sanding, and a little more fiddling around and she will be ready to cover. Hoping for tomorrow on that. As Kent suggested, I'll take plenty of pics of the covering and document it enough to make a small HowTo out of it. I'll post it here and probably boil it down into a pdf to make it handy if all turns out OK.

Oh, and a couple more pics too.

Mark

Radio not programmed for elevons but we have movement with good throws.
Control Surfaces Thermal Bleed (0 min 32 sec)
Quick61 is offline Find More Posts by Quick61
Reply With Quote