Thread: Discussion Fy-31ap
View Single Post
Old Jul 22, 2012, 10:33 PM
NorCalMatCat is offline
Find More Posts by NorCalMatCat
FPV Electronics For Life!
NorCalMatCat's Avatar
United States, CA, Arcata
Joined Oct 2011
2,669 Posts
Quote:
Originally Posted by HotAir2 View Post
I want one of these to make my glider safer (5m scale). But from what I can tell, you can only connect up three servos, elevator, rudder and aileron. My glider has two aileron servos and two flap. Ideally the FY31AP would have six servo channels and a couple for switches.

Thoughts? Is there some way round this?

Thanks, Neal
FY31AP doesn't do flaps... I assume you are saying you have your ailerons on 2 channels... is this because you do flapperons? Otherwise a Y harness would work just fine, I do not know if the FY31AP can handle flapperon type setup though... I do know it can be programmed for elevrons and v-tails, but I dunno about flapperons.
NorCalMatCat is offline Find More Posts by NorCalMatCat
RCG Plus Member