View Single Post
Old Jul 20, 2012, 10:18 PM
plane_tech is online now
Find More Posts by plane_tech
Theoretical balsa dust maker
plane_tech's Avatar
United States, MI, Kalamazoo
Joined Oct 2007
2,413 Posts
Nodd,
In post 7, where you are showing the brass guide tubes going through the ribs, how much mat'l is left between the brass tube and the outer edge of the rib? I am doing a setup similar to yours with regards to the joiner tubes, however, I am thinking that there is not enough mat'l left there to support much of anything. It looks like a little less than 0.0625" from the angle.
Is this a spot of concern with you am I over thinking the situation ?
plane_tech is online now Find More Posts by plane_tech
Reply With Quote