View Single Post
Old Jul 19, 2012, 05:16 AM
aBUGSnightmare is offline
Find More Posts by aBUGSnightmare
Registered User
Joined Jul 2011
188 Posts
Quote:
Originally Posted by Goofy23 View Post
we got the Microwii
http://flyduino.net/MicroWii-ATmega3...OF-MultiWii-FC

more instructions will follow, but its avaiable from now.
Hi there,

took some time but finally it's available here: http://flyduino.net/NanoWii-ATmega32...-MultiWii-FC_2

The MICROWII 10DOF all-in-one flightcontroller

Here's a short list of it's features:
- based on ATmega32U4 with Leonardo Bootloader
- 10DOF sensor array
- MPU-6050 (GYRO/ACC)
- HMC-5883L (MAG)
- MS5611-01BA01 (BARO)
- Power supplied by 2S to 4S LiPo
- LiPo voltage divider for 2S to 4S, selectable via solder jumper
- Spektrum Satellite support with dedicated connector (on bottom), for standard Spektrum cable
- Bluetooth/GPS connector (on bottom; only GPS or Spektrum can be used at a time since the 32U4 only has one UART)
- optional LED driver for flight mode signalization (footprint on bottom; i.e. with RGB-LED, similar to the DIVIDE et IMPERA! Rev2 board)
- Onboard USB interface; so no need for a FTDI-adapter
- I2C interface for expansions
- High-Speed PWM with 11-bit resolution
- supports all configs up to OKTO with cam-stab support
- 6 receiver inputs
- PPM-Sum signal support

Hope you'll like it!
aBUGSworstnightmare
aBUGSnightmare is offline Find More Posts by aBUGSnightmare
Reply With Quote