Thread: Discussion Crius MultiWii AIO boards
View Single Post
Old Jul 18, 2012, 01:12 PM
TS00 is offline
Find More Posts by TS00
Ape-pilot Extraordinaire
TS00's Avatar
Canada, NB, Moncton
Joined Jun 2011
1,508 Posts
Quote:
Originally Posted by MuddyWulf View Post
TS00, thanks so much for the help. You have been the most helpful so far. You gave a little information but it provided much motivation. I went over everything again.
The board was mounted in "+" fashion rather than "x". That corrected pitch/roll issue.
I flashed the the board and began from scratch.
Calibrated throttle range for individual ESC's.
set all ranges to 1000-1500-2000
calibrated acc & mag.
The only problem I am now having is getting the quad to lift. The quad is very light on power up and wants to lift but at full throttle it just doesn't. I have checked motor revolution and ensured that props are mounted correctly. Almost there!!! YAY!! Any suggestions on the low throttle output? One other thing I have noticed is that "debug 1" at the bottom of the gui has numbers that change with the "alt" box (left side of the multiwii gui). The gray line on sensor display is always up and down not straight. Is that right? Thanks again for being a huge help.
Glad to hear you're making progress. Can you provide a bit more info on the problem?

When you throttle up, do all the motors start revving as you would expect?

The gray line - can you post a screenshot of your gui?
TS00 is offline Find More Posts by TS00
Reply With Quote