View Single Post
Old Jul 17, 2012, 08:07 PM
nogas is offline
Find More Posts by nogas
Because gas is for BBQ's
nogas's Avatar
Australia, QLD, Brisbane
Joined Feb 2011
746 Posts
I've got the ET up and running and am starting to play around with it. Is there any templates for info positions? or is it just a case of adding it all my self? Also how do i add the graphical readouts? i can only add numerical at the moment.

I also went to run the servo wizard but it asked me to set the cruise throttle and servo positions. How do most do this? Just make a note of where they hold sticks for the desired speed? and will it matter if i disconnect the motor for this process, (doing this in the house after the kids go to bed and although i love the sound of a brushless motor winding up, my family strangely doesn't share the same love at 10pm)
nogas is offline Find More Posts by nogas
Reply With Quote