View Single Post
Old Jul 16, 2012, 10:49 AM
rcbif is offline
Find More Posts by rcbif
Do a Barrel Roll!
rcbif's Avatar
United States, OH, Medina
Joined Jun 2005
1,049 Posts
Quote:
Originally Posted by iulian View Post
I have the same problem as rcbif. I tried with digital servo HK-D922MG, HK-D933MG and an analog servo. Keeping the same settings for PID, the wobbling is higher for servo 922 which has a greater speed. If I put on high servo channel 4 is even worse.
And did you change the yaw setting in the mixer editor from low to high for your digital servo as well?

No looking good so far.
rcbif is offline Find More Posts by rcbif
Reply With Quote