Originally Posted by beenflying
That's good to hear, Mike. What heli did you end up putting it on and what servos, arm length etc.
I put it on a Copterx 450 SE V2 with MG-14 analogue servos (these get bad press but worked well on this when it had the Beastx) the balls are at about 12.5mm. The heli is more planted than it's brother that still has a 3X1000 on it - yesterday it was quite gusty here and it was amazing to watch it sitting in the wind and fighting to maintain it's attitude - it always impresses me when they do that