View Single Post
Old Jul 15, 2012, 10:36 AM
icah is offline
Find More Posts by icah
Registered User
Hungary, Pest County, Tököl
Joined Oct 2010
444 Posts
Quote:
Originally Posted by rumbey View Post
Almost finished my Q450 quad with KK2 board installed.

I have followed instructions for esc calibration but can anyone explain how long I should hold down the 1 and 4 button and at what stage I change throttle for High to Low on the TX.

Some of the motors are not spinning up the same as others and I don't think the calibration was completed successfully.
Turn on your TX. Raise throttle to 100%. Switch on the FC while holding buttons 1 and 4. Wait for the beeps from the escs. As soon as you hear the beeps move throttle down to zero, you will hear one or more beeps. That's it. If not all of the motors spin up afterwards raise the minimum throttle to 20 in the misc settings of the FC, that should help.
icah is offline Find More Posts by icah
Reply With Quote