View Single Post
Old Jul 14, 2012, 01:11 AM
huntermanmt is offline
Find More Posts by huntermanmt
Registered User
huntermanmt's Avatar
Joined Jun 2012
14 Posts
Originally Posted by AeroR View Post
Hi all,
I have got the same issue, motors not arming at all.I just got my F550(turned into a Y6 with Naza and follwed all the steps in Naza Assistant. stick movement matched the transmitter movements.
Im using Aurora 9 with Optima 9 receiver.
Im not able to power this thing up.
Please anyone can help walk me through the set up?I don't know what Im missing and Im new to RC and multirotors.
Im using the same TX/RX setup.

I flew yesterday, couldnt figure it out why I was arming but had no control of my throttle, I simply overlooked the throttle hold switch being on.

Another problem I had in the beginning were the dual rates and expo. I had made adjustments and there wasnt enough stick travel detected to arm the naza. I changed them back to original settings.

Also, in the very beginning, I initially made the mistake of plugging in the motors (positive, negative, ground) the opposite way into the naza, i just flipped and plugged them in the right way.

Maybe this will help.
huntermanmt is offline Find More Posts by huntermanmt
Reply With Quote