Thread: Discussion Blade 130X Problem Thread
View Single Post
Old Jul 06, 2012, 09:07 AM
everydayflyer is offline
Find More Posts by everydayflyer
Southern Pride
everydayflyer's Avatar
Haralson County GA. USA
Joined Oct 2004
34,852 Posts
That sounds like a bad power connection perhaps. Could be bad solder joint at the main power leads at battery end or the main board end. I know I have found this on the mCPX and also the mCPX leads are only secured to the main board with a bit of silicon rubber toserve as a strain relief which is not really all that secure IMO. The leads tend to be a bit short and it is difficult to connect and disconnect the battery without pulling on them. I put a longer length of heat shrink on the battery end of the leads while I am resoldering them and also use hot glue to secure the leads to the main board.

Charles
everydayflyer is offline Find More Posts by everydayflyer
Reply With Quote