View Single Post
Old Jul 06, 2012, 08:52 AM
garris2 is offline
Find More Posts by garris2
Registered User
Melbourne, Australia
Joined Jan 2008
1,075 Posts
Quote:
Originally Posted by Gordon65 View Post
Hi all,
I am setting up a tractor prop plane so I need to get the pitot probe out onto the wing so it isn't affected by propwash. I want to cut down on wires and connectors, so could someone checkout this schematic and let me know if it will work.

Thanks for any help.
I think better to run an extra connector for the sensor as I measured the I2C bus voltage and its different to the servo voltage. The sensor doesn't use much current so you wont see any voltage drop if you put the sensor out in the wing.

http://www.rcgroups.com/forums/showp...82&postcount=2

Geoff
garris2 is offline Find More Posts by garris2
Reply With Quote