View Single Post
Old Jul 03, 2012, 01:25 AM
m_beeson is offline
Find More Posts by m_beeson
FPV junkie
m_beeson's Avatar
United States, UT
Joined Jan 2011
3,610 Posts
Quote:
Originally Posted by captward View Post
Hi Bill:

When I run the Servo Analysis wizard and get to the point where the instructions instruct to shut down my transmitter, it does not bind back to my receiver when I turn it back on. I am using a Futaba T14MZ with the R6014HS receiver. Has anyone encountered this issue and how did you resolve it?

I have the Flight Data Recorder, OSDPro, GPS Expander, G-Force module all with the updated firmware. Anything I am doing wrong?

Thanks.
Once it starts counting down, hit the power button, and make sure that your throttle stick is all of the way down. otherwise it delays turning on, and prompts you to answer a question.

It should have enough time to bind, but it is close.


I am using the 12fga, but I also have chainlink on it, so I am not sure how fast the Faast system binds.
m_beeson is offline Find More Posts by m_beeson
Reply With Quote