Thread: Discussion Blade 450 3d
View Single Post
Old Jul 02, 2012, 12:36 PM
Kawi is offline
Find More Posts by Kawi
Joined Sep 2011
750 Posts
I looked at the linkage arms and at neutral, they were not at all even, it looked like somebody had unscrewd the end of one to make it longer, the servo arm was fine and centered, it was just the linkage was too long. The swash was tilting left and back, it was uneven exactly on the side that I had to trim, both for elevator and aileron. So I just twisted them down to an even length and now it hovers stable.

As far as the hard landings I guess it's just the way it is, I'll have to just take more caution when putting it down.
Kawi is offline Find More Posts by Kawi
Reply With Quote