Thread: Discussion Apparition-II twin issues
View Single Post
Old Jun 30, 2012, 05:34 AM
stalyoni is offline
Find More Posts by stalyoni
high flyer
stalyoni's Avatar
Australia, WA, Geraldton
Joined May 2008
3,205 Posts
Quote:
Originally Posted by bill34207 View Post
Photo 2 bothers me. I'm surprised it's cooling at all with the water pickups so high. I'd suggest loosening the setscrew and lowering them so the tips are a little closer to the bottom of the sponsons.
that would put the tips under the water and will only create drag wont it. Arent they only just meant to be on the top of the water so the water shoots up into the tubes?

Just read that this guy used 4s lipo and 38mm props with this motor.

http://www.hobbyking.com/hobbyking/s...dProduct=15190

which is pretty similar to mine but I would like to know how many amps it was pulling
stalyoni is offline Find More Posts by stalyoni
Reply With Quote