Thread: Discussion Molded Ritewing Zephyr ZII
View Single Post
Old Jun 29, 2012, 11:39 PM
tobermei is offline
Find More Posts by tobermei
Registered User
Mt Tamborine, Queensland, Australia
Joined May 2008
758 Posts
Quote:
Originally Posted by flyn View Post
Cool, cheers for the reply, I had considered a slight downward tilt due to the way cameras tend to expose for the average lighting conditions in the image, under exposing the ground. Have you ever found that an issue with a camera positioned straight ahead?
I'm positioning mine straight ahead but with a mount that will enable me to angle it downward if required.

I've also finished 3/4 of the laminating and it wasn't all that difficult after all. I was concerned that the heat of the iron might cause problems with the foam melting but that didn't end up being a problem. I tested to see how firmly the laminate adheres on one of the wing tip ends and it's holding very firmly.
tobermei is offline Find More Posts by tobermei
Reply With Quote