Thread: Discussion Molded Ritewing Zephyr ZII
View Single Post
Old Jun 28, 2012, 11:25 PM
brosius85 is offline
Find More Posts by brosius85
never mind the boll⁣⁣⁣ocks
brosius85's Avatar
Australia, NSW
Joined Dec 2010
1,256 Posts
set the trows by putting a ruler on the tip of the elevon, it should move about 10mm up and 10mm down for elevator, and 15mm up and 15mm down for ailerons.

for starters trim the elevons flat with the top of the airfoil, then a few mm of up reflex.

i like expo at about 60% and i dont use dual rates. it really is all personal prefrence though.

put the pushrod in the highest hole in the elevon horn for maximum servo resolution.
brosius85 is offline Find More Posts by brosius85
Reply With Quote