Thread: Discussion Hobby King Bixler EPO ARF
View Single Post
Old Jun 28, 2012, 06:53 PM
DragonFly711 is offline
Find More Posts by DragonFly711
Will try to fly anything.
DragonFly711's Avatar
United States, TX, Athens
Joined Dec 2011
110 Posts
Quote:
Originally Posted by b.b.4 View Post
Can the v1 Bixler be TAPED together to make servo replacement easy, or to up-grade the motor and esc ???????????.
Is their a post somewhere regarding this ? thx in advance..........
You can use the CNC mount shown above in my earlier post that allows you to change motors without having to remove it from the fuselage. Costs about $16.
Just google bixler cnc motor mount for info.

As far as changing out the esc, that's down in the fuselage at the front and as long as you have wires with connectors on both ends between the motor and esc, you could just unhook it and change out an esc easily.

Servos are probably the hardest thing to replace inside the fuselage but can be done with some patience.

I don't know if taping the two halves of the fuselage together would be that good of an idea. I guess you could or just glue it together in spots before you tape it where it could be cut back apart easily.

Someone else might have a better idea but I glued mine together and if a servo goes bad internally, I'll figure a way to replace it.

Good luck with it,

Donnie
DragonFly711 is offline Find More Posts by DragonFly711
Reply With Quote