Thread: Discussion HoverflyGIMBAL settings thread
View Single Post
Old Jun 28, 2012, 12:15 AM
Adidas4275 is offline
Find More Posts by Adidas4275
manual flying apologist
Adidas4275's Avatar
United States, CA, Fresno
Joined Mar 2011
6,940 Posts
when did the new firmware drop?

ill have to look for it.

mine is very close (still getting some roll/yaw coupling) i have moved the board away from the camera and I am getting less coupling.

i hooked up my Rx to the board today (using a different battery so no common ground and I only hooked up the singal wire) and it worked but it was behaving weird. It I am going to try moving the power to the HF Gimbal board and isolate the servos from the power and see if that works. I might try and power my servos off the flight pack an not a separate battery (might make a difference)

so if there is a new firmware ill update tomorrow and report back!
Adidas4275 is offline Find More Posts by Adidas4275
Reply With Quote