View Single Post
Old Jun 27, 2012, 09:15 PM
croyal918 is offline
Find More Posts by croyal918
I love to engineer & design!
United States, OK, Tulsa
Joined Jun 2012
4 Posts
Sounds like it will be cool Jake, you have any pictures? Andy, I bought my led's on ebay. Here are some better pictures of the setup i've created. This is as close to as a tutorial as I will likely do for now
I used shrink tubing, magnet wire, green and blue smd leds and a resister (but i at least need to add one more).
Name: Ladybird LED setup 1.jpg
Views: 745
Size: 214.9 KB
Description:
I ran the blue and green smd's on separate circuits to maintain brighter lighting on all Led's. I used all three pins on the bind plug, using original plug w/ cut loop & adding an individual wired pin from another connector i bought. the three wires operate both of the led circuits, while sharing the middle positive (+) wire. (the red wire is actually a ground wire (-) , used red wire only bc i accidentally damaged the other black wire during this process)
Name: Ladybird LED setup 2.jpg
Views: 704
Size: 222.7 KB
Description:
croyal918 is offline Find More Posts by croyal918
Reply With Quote