Thread: Discussion Multiplex Fun Cub
View Single Post
Old Jun 26, 2012, 05:00 PM
zmonster97 is online now
Find More Posts by zmonster97
Team Aztech Aeromodels!
zmonster97's Avatar
United States, PA, Allentown
Joined May 2011
3,021 Posts
Quote:
Originally Posted by Starving Bushman View Post
Thanks Dell. It is a Turnigy D3530-14 1100kv http://www.hobbyking.com/hobbyking/s...dProduct=18225 . I watched a video but it was an older, much different motor than what I have. It involved grinding a flat spot on the shaft and some other steps that I am not sure about. Not knowing how similar the process is between the 2 different motors I am trying to gather as much info as I can before attempting.
I'm pretty sure all you would have to do is take off the clip, unscrew the set screws on the front that hold the shaft on and gently tap the shaft through the motor.

I'm not 100% sure though, so someone chime in if I'm wrong.
zmonster97 is online now Find More Posts by zmonster97
Reply With Quote