Thread: Discussion Multiplex Fun Cub
View Single Post
Old Jun 26, 2012, 04:15 PM
Del-Dredd is offline
Find More Posts by Del-Dredd
Registered User
Del-Dredd's Avatar
Near Aberystwyth - Wales
Joined Aug 2004
2,135 Posts
Motor ident would help, 3536 110o Kv etc.

Usually best to remove Bell from the motor doing it this way round or you will be stressing the bearings.

May not need to take shaft out, most Emax you just remove rear E clip and unscrew grub screw on the bell then push shaft through (usually in a vice or drill press) using a long socket etc to give clearance for shaft.

Re-tighten grub screw and put E clip into slot on what is now the prop end of shaft.

Probably a video on YouTube which is better than a thousand words as they say.
Del-Dredd is offline Find More Posts by Del-Dredd
Last edited by Del-Dredd; Jun 26, 2012 at 04:24 PM.
Reply With Quote