View Single Post
Old Jun 22, 2012, 03:36 PM
Jake8131 is offline
Find More Posts by Jake8131
Jake From Planet Mascoutah, IL
Jake8131's Avatar
United States, IL, Mascoutah
Joined Dec 2010
3,712 Posts
Quote:
Originally Posted by SG Mason Knives View Post
I checked out my V911 and it doesn't have this problem. The screw is close to the swash plate, but doesn't actually make contact and I have my throws set at 120% on my 9X. Yes I actually get full movement with out going past the stops on the servos. I think it may just be production tolerances, I got one that is close to what it is suppose to be, while yours is at the other end of the tolerances. I would be interested to see just how many of the V911s here have the same problem as yours. There aren't even any sort of wear marks on the bottom of my swash or the top of the collar of mine.
The raised edge on the collar goes down..against the bearing....
Jake8131 is offline Find More Posts by Jake8131
Reply With Quote